 |  | 
Description:
NetCom's NCDFAB Firewire to ATAPI/IDE Bridge is ideally suited for tailgating interfaces such as removable-media drives CD-ROM, CD-R, CD-RW, DVD-ROM, DVD-RAM, tape drive, and hard disk drive. It allows IDE drives (Master and Slave) to be connected to FireWire 800 (IEEE 1394b) serial bus in a plug-and-play fashion. Both ATA and ATAPI devices are supported using the same firmware.
NCDFAB allows users to easily hot-swap IDE drive without interrupting the current operation.
NCDFAB provides the perfect solution for data backup and transferring of data between computers using IDE (ATA/ATAPI) devices.
|
Features:
- FireWire 800 (IEEE 1394b) to IDE (ATA/ATAPI) Bridge Board:
- IDE (ATA/ATAPI) Interface: Female 40-Pin
- Both ATA and ATAPI devices are supported using the same firmware.
- 1394a PHY: Ti's TSB81BA3 IEEE 1394b 800Mbps PHY
- 1394 Bus Transfer Rate: 100/200/400/800 Mbps
- FireWire (IEEE-1394) to ATA Native Bridge Controller
- Complies with T13's ATA/ATAPI-7 Draft Specification:
- PIO Mode 0-4
- DMA Mode 0-2
- Ultra DMA Mode 2, 4, 5, 6
- Supports 48-bit addressing for large hard drives (>128GB).
Product Content:
- NetCom's NCDFAB Firewire to ATAPI/IDE (Master / Slave) Internal Bridge Board
- Firewire Cable NOT INCLUDED
Before you purchase this item, please ensure that you have verified compatibility with system by visiting the manufacturer's web site.
We assume no responsibility and will not accept full refunds for items purchased that are not compatible with your system configuration.
|
Conditions:
Warranty:
|
|
